Garland Convection Microwave Oven User Manual download pdf (Page 7)

Part # 1955203 (12/06) Page 7

C. Install the interconnecting ﬂue parts, carefully

following the instructions contained in the stacking

kit. Pay particular attention to the type of ovens you

are stacking and be sure to follow the corresponding

instructions.

D. Check leveling of unit four (4) ways (using a

common carpenter’s level on the rack inside the

oven).

E. Maintain clearance from combustibles.

CAUTION: Disconnect Both Unites from electrical

Supply Before Servicing.

Electrical Connections

Before attempting the electrical connection, the rating

plate should be checked to ensure that the unit’s electrical

characteristics and the supply electrical characteristics

agree.

Installation of the wiring must be made in accordance

with U.L.  Commercial Electric Cooking Appliance

Standards, Local and/or National Electrical Code,

ANSI/NFPA -, or the Canadian Electrical Code,

CSAC . as applicable.

1. Switch panel size

2. Overload protection

3. Wire type

4. Wire size

5. Temperature limitations of the wires

6. Method of connection (Cable, Conduit, etc.)

INSTALLATION Continued

e service line will enter through the rear of the unit and

is to be connected to the terminal block (see diagram).

e terminal block is accessed by removing the lower

front cover. Removal of the body side is not necessary.

Input voltage and phasing must match the units

voltage and phasing. Wiring diagram is attached to

the main back of each oven. Visually check all electrical

connections. Energize electric service to units. e range

is wired standard for three phase connections. If it is

necessary to change to single phase, please refer to wiring

diagram attached to the rear of the oven. Service and

unit voltage must agree.

1 2 3 4 5 6 7 8 9 10 11 12 ... 43 44

No comments

Garland Convection Microwave Oven User Manual Page 7