Garland GT SERIES HEAVY DUTY GAS COUNTER EQUIPMENT User Manual download pdf (Page 9)

Page 9

PRE INSTALLATION

INSTALLATION

General

1. Carefully remove appliance from carton or crate. Burner

tie wires and other packing material should be removed

at this time. The protective material covering the stainless

steel should be removed immediately after the appliance

is installed, before it is  red.

2. Remove top grates and place out of the way, to prevent

damage.

3. These appliances must be installed under an adequate

ventilation system. Refer to section titled Ventilation for

further instructions.

4. All burner adjustments and setting shall be made by a

quali ed gas technician.

Gas Connections

The local gas authority should be consulted at the

installation planning stage in order to establish the

availability of an adequate supply of gas and to ensure

that the meter is adequate for the required  ow rate. The

pipe work from the meter to the appliance must be an

appropriate size.

All  xed (non-mobile) appliances MUST be  tted with an

accessible upstream gas shut o valve as a means of isolating

the appliance for emergency shut o and for servicing. A

union or similar means of disconnection must be provided

between the gas-cock and the appliance.

A manually operable valve must be  tted to the gas supply

to the kitchen to enable it to be isolated in an emergency.

Wherever practical, this shall be located either outside the

kitchen or near to an exit in a readily accessible position.

Where it is not practical to do this, an automatic isolation

valve system shall be  tted which can be operated from a

readily accessible position near to the exit.

In locations where the manual isolation valve is  tted or the

automatic system can be reset this notice MUST be posted:

“ALL DOWNSTREAM BURNER AND PILOT VALVES MUST

BE TURNED OFF PRIOR TO ATTEMPTING TO RESTORE THE

SUPPLY. AFTER EXTENDED SHUT OFF, PURGE BEFORE

RESTORING GAS.”

Damage Check

Damage check: Check carton or crate for possible damage

incurred in shipping. After carefully un-crating, check for

“concealed” damage. Report any damage immediately to

your carrier.

Rating Plate

The rating plate is a xed to a bracket mounted at the rear

of the unit but visible from the front. The grease drawer may

need to be removed to view rating plate.

The correct type of gas for which the unit was manufactured

is noted on the rating plate, and this type of gas must be

used.

When corresponding with the factory or your local

authorized factory service center regarding service problems

or replacement parts, be sure to refer to the particular model

by the correct model number (including the pre x and

su x letters and numbers) and the warranty serial number.

The rating plate a xed to the appliance contains this

information.

We suggest installation, maintenance and repairs be

performed by your local authorized service agency listed in

your information manual pamphlet.

In the event you have any questions concerning the

installation, use, care or service of the product, write or call

our Product Service Department.

This product must be installed by professional personnel as

speci ed. Garland/U.S. Range products are not approved or

authorized for home or residential use, but are intended for

commercial applications only. Garland / U.S. Range will not

provide service, warranty, maintenance or support of any

kind other than in commercial applications.

Part # 4531237 Rev 2 (09/09/13)

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 47 48

Comments to this Manuals

No comments

Garland GT SERIES HEAVY DUTY GAS COUNTER EQUIPMENT User Manual Page 9

Comments to this Manuals

Related products and manuals for Stoves Garland GT SERIES HEAVY DUTY GAS COUNTER EQUIPMENT